Amethyst Flight

$289.00
(No reviews yet) Write a Review
Width:
11.00 (in)
Height:
10.00 (in)
Depth:
11.00 (in)
Current Stock:

This diffuser has an incredible deep purple amethyst atop a mound of hand forged splash copper and surrounded by a swirl of brass. The vessel has a creamy oatmeal base with flowing greys and soft browns. The pure copper sculpture was hand forged from melted copper and attached to an all copper base. The sculpture was then heat patinated to bring out the colors and sealed. It is a unique, hand-made piece of art.

It measures approximately 11 inches in diameter and 11 inches in height.

All of our diffusers include a 10mL bottle of our Citrus Sacra essential oil. This is our own proprietary blend of six citrus fruits and our own 100% pure frankincense (boswellia sacra).

Our Essential Oil Diffusers use the latest in ultrasonic technology to break up the blending of essential oils and water into mist of micro-particles and disperse them into the air. This type of diffusion creates a therapeutic mist that helps to humidify the air and features the gentle sound of trickling water. Allowing you to benefit from the aromatherapy of the essential oils, and the ionizing and humidifying effect of the water vapor in your home or spa.  This diffusion method doesn't utilize heat, which maintains essential oil integrity and holistic properties.

How it works:

An ultrasonic diffuser utilizes electronic frequencies to cause a small disk under the surface of the water to vibrate at a very fast rate. These ultrasonic vibrations break the essential oil into tiny micro-particles, dispersing the oil in a fine mist.  These tiny particles are more easily absorbed by the lungs for a greater therapeutic effect on the body, mind, and spirit. No heating or burning means the properties of the oil are not broken down.

Instructions for setup and optimal usage:

  1.  Place the silver mist unit in the center of the stoneware vessel & thread the cord through the hole.  Push the black plug firmly into the hole.
  2.  Fill with bottled /filtered drinking water so that the water level is just above the top of the water level sensor (black bar) on the mist unit.
  3.  Connect the mist unit to the transformer and plug the transformer into the main power supply.
  4.  Place the copper lotus flower on top of the stoneware vessel.  (Use caution as points of flower may be sharp.) Adjust placement and lotus leaves for optimal mist without splashing.
  5.  Add a couple (less, more often is better than a lot all at once) drops of your favorite essential oil and enjoy!

 

               -  Use bottled/filtered drinking water water. Hard water or water with a lot of minerals will clog the diffuser. Periodically change water to keep clean. When water becomes dirty, replace with clean water. Dirty water will affect the performance of the diffuser. DISTILLED WATER OR SOME R.O. WATER WILL KILL THE NEBULIZER.     

               -  The diffuser sends out small jets of water while in operation. Do not place the unit where water spillage or condensation will cause damage to furniture, electric products, floors, or anything else that may be affected by water damage. 

              -  Suggested usage of diffuser motor is no more than 8 hours a day. Unplugging the unit when not in use(separating the cord at the junction works too) will increase the life of the nebulizer. Letting the diffuser run out of water repeatedly will shorten the life of your nebulizer.